Using the TAR-3 Resistance Meter with Array Bar
In addition to a TAR-3 Resistance Meter kit you will need a TAR-3 Array Bar kit (1.5m)
Kit Contents
- Array Bar, 1.5m with four 18mm diameter holes (1.6kg)
- Red 4mm plug to 4mm plug cable (1.8m), One off
- Blue 4mm plug to 4mm plug cable (1.8m), One off
- Insulation Bush, four off
- M8, 120mm Stainless Steel bolts, three off (SEBF-M8-120-A2)
- M8 Stainless Stainless nuts, four off (HPN-M8-A2)
- M8 Stainless Stainless lock (half) nuts, six off (HFN-M8-A2)
- Washer 8mm hole 25mm Diameter, eight off
- Washer 8mm hole Std size, eight off
The Array Bar Kit does not contain probe pins - use the probe pins supplied with the TAR-3 Resistance Meter kit
Figure (1) TAR-3 Resistance Meter Array Bar (Wenner alpha)
Assembling the Array Bar - Wenner Alpha Array
- The Array Bar is attached to the TAR-3 Frame using the P1 and P2 probes. (see figure 1) above.
- Group P1 and C1 on the opposite side to C2 and P2.
- Use the locking nuts on P1 and P2 - remember to adjust the length of P1 and P2 so that they protrude further than C1 and C2.
- P1 and P2 should penetrate the ground before C1 and C2!
Note: The Array bar and two extra probes weigh 2kg more than the standard Twin probe unit. (each probes weighs 0.185kg)
Figure (2) TAR-3 Resistance Meter 1.5m Probe Separation)
Twin Probe - 1.5m probe Separation using the Array Bar
NB The remote probe separation should be 1.5m (
not 0.5m!)
Note The distance from the remote probes should be 30 x 'Probe separation' which is 30 x 1.5m = 45m. Use the TAR-3 extension lead to ensure the remote probes are at a distance of '30 times' (45m)
- The Array Bar is attached to the TAR-3 Frame using the M8, 120mm bolts. (see figure 2) above.
- Use one of the 1.8mm Red leads supplied in the kit array bar kit and the 1.8m Blue lead supplied with TAR-3 kit
The layout and routing of the leads is shown schematically - use the Velcro cable ties to attach to the frame and Array Bar.
The TAR-3 Resistance Meter Array Bar kit is an addon unit for users wishing to use a Wenner Array probe configuration. The Array Bar kit contains all the
extra equipment needed. The kit uses the probes supplied with the TAR-3 Resistance Meter kit.